Filter
Top Products
27
3. Getting Started
This chapter outlines the steps required to set up your phone. Follow the procedure below
to get started.
Battery
Always switch off the power and disconnect the charger before removing the battery. Avoid
touching electronic components on the battery and inside the battery compartment.
Installing the Battery
1. Insert the top of the battery under the plastic retainer clip. The + and – terminals on the
battery should line up with the metallic contacts in the battery compartment.
2. Push down on the bottom section of the battery until it clicks into place. It should be
aligned with the bottom of the phone.
3. Replace the battery door so that it covers the entire battery. Slide the cover upwards
until it locks into position. Make sure the battery door is secure.
Charging the Battery
Your phone is powered by a rechargeable battery. The battery is not fully charged when you
purchase your phone, but there may be enough power in the battery to turn the phone on.
Charge the battery with the procedure indicated below.
Note: For maximum battery performance, it is recommended that you completely charge the
battery before using the phone for the first time. A new battery’s full performance is
achieved only after three complete charge and discharge cycles.
1. Plug the charger into a standard AC outlet.
2. Pull the rubber USB cover away from the USB port and rotate it 90 degrees.