Configuring PAD/ATPAD Ports 51
Remote PAD Parameter Table Record
#1 Parameter Number
Range: 0 to 127
Default: 0
Description: Specifies the X.3 parameter sent to a remote PAD that has just
connected to a local PAD port. The selections correspond to the
parameters in the PAD Profile Table:
• #1: PAD Recall character (0, 1,32 to 126)
• #2: Echo (0, 1)
• #3: Data Forwarding Character (0, 1 to 127)
• #4: Idle Timer Delay (0, 1 to 255)
• #5: Device Flow Control (0, 1, 2)
• #6: Service Signals Control (0, 1, 4, 7 to 15)
• #7: Break Signal Operation (0, 1, 4, 8, 16)
• #8: Discard output (0, 1) (not supported by the 6500
PLUS
)
• #9: Padding after Carriage Return (0 to 255)
• #10: Line Folding (0, 1 to 255)
• #11: Speed (0-18) (not supported by the 6500
PLUS
)
• #12: PAD Data Restraint (0,1)
• #13: Line Feed Insertion after CR (0, 1, 2, 4)
• #14: Padding after LF (0 to 255)
• #15: Editing (0, 1)
• #16: Character Delete (0 to 127)
• #17: Line Delete (0 to 127)
• #18: Line Display (0 to 127)
• #19: Editing Type (0, 1, 2, 8, 32 to 126)
• #20: Echo Mask (0 to 255)
• #21: Parity Treatment (0 to 7) (normally not used)
• #22: Page Wait (0, 1 to 255)
• #100: Break Character (0 to 127)
• #101: Echo Substitution Toggle Character (0 to 127)
• #102: Echo Substitution Character (0 to 127)
• #103: XON Character (0 to 255)
• #104: XOFF Character (0 to 255)
• #105: Control Signal (EIA-232-D) Data Restraint (0 to 3)
• #106: Network Parity (0 to 4)
• #107: Idle Disconnect Timer (0 to 255)
