A SERVICE OF

logo

132
Programming Commands
CONTS Continuous Sweep
CONTS
Continuous Sweep
Syntax
Preset State: CONTS
Legacy Products
8560 series, 8566A/B, 8568A/B
Description
The CONTS command sets the analyzer to continuous sweep mode. In the continuous sweep mode, the
analyzer takes its next sweep as soon as possible after the current sweep (as long as the trigger conditions
are met). A sweep may temporarily be interrupted by data entries made over the remote interface or from
the front panel.
NOTE The functions of the command CONTS are identical to the S1 command
(page 306).
CONTS
LF
CR
SP
,
;