A SERVICE OF

logo

306
Programming Commands
S1[one] Continuous Sweep
S1[one]
Continuous Sweep
Syntax
Legacy Products
8566A/B, 8568A/B
Description
The S1 command sets the analyzer to continuous sweep mode. In the continuous sweep mode, the
analyzer takes its next sweep as soon as possible after the current sweep (as long as the trigger conditions
are met). A sweep may temporarily be interrupted by data entries made over the remote interface.
NOTE The functions of the command S1 are identical to the CONTS command
(page 132).
S1
LF
CR
SP
,
;