A SERVICE OF

logo

312
Programming Commands
SMOOTH Smooth Trace
SMOOTH
Smooth Trace
Syntax
Prerequisite Commands: TS when using trace data.
NOTE TRA corresponds to Trace 1, TRB corresponds to Trace 2, and TRC corresponds
to Trace 3.
Legacy Products
8566A/B, 8568A/B
Description
Smooths the trace according to the number of points specified for the running average.
Each point value is replaced with the average of the values (in measurement units) of the given number
of points centered on it. Increasing the number of points increases smoothing at the cost of decreasing
resolution. If the number of points is an even number, then the number of points is increased by one.
Smoothing decreases at the endpoints.
NOTE Some differences may be noticed between the smoothed trace in the legacy
analyzers and the smoothed trace using the same signal in X-Series analyzers.
SMOOTH TRA
S
P
TRB
TRC
;,
number
of points