100
Dukane Manual Part No. 403–566–01
DPC
™
II Plus and EZ Welder System – User’s Manual
To erase all the stored setups, move the cursor from
ERASE CURRENT SETUP (see Figure 9–11) to
down to ERASE ALL SETUPS and press ENTER. A
confirmation message is displayed. Move the cur-
sor down to YES as shown in Figure 9–14. Press
the ENTER key to delete the setup files.
ERASE ALL SETUPS
NO
YES
A progress message (see Figure 9–15) appears for
about 8 seconds. When the process is complete,
the display returns to the Process Setup menu as
shown in Figure 9–2
ERASING ALL SETUPS
IN PROCESS...
.
Part Count
The parts count option (see Figure 9–3) offers three
options. The three choices are to reset the counter,
count suspect/bad parts and preset the counter as
shown in Figure 9–16.
PART COUNT
RESET PART COUNT
COUNT SUS/BAD PART
PRESET PART COUNT
The count replaces the - - - in the upper left of the
operate screen (see Figures 7–3. 7–4, 7–31 and 7–53).
Reset Part Count
This function resets the parts counter back to zero.
With the cursor at the reset function, press the
ENTER key. The confirmation screen shown in
Figure 9–17 is displayed next.
RESET PART COUNT
NO
YES
Use the decrement key to move the cursor down
one line to YES and press the ENTER key. The
counter will be reset and the menu returns to the
part count selection menu shown in Figure 9–16.
Count Suspect/Bad Part
The second option controls the suspect/bad part
counter. The counter can be set to count all parts or
only the good parts. To configure the counter, move
the cursor down to COUNT SUS/BAD PART (see
Figure 9–16) and press ENTER. A confirmation
screen (shown in Figure 9–18) is then displayed.
COUNT SUS/BAD PART
NO
YES
To count all parts, move the cursor to YES, press
ENTER and the menu returns to the part count se-
lection screen shown in Figure 9–16. To exclude
bad/suspect parts, move the cursor to NO and press
ENTER. The bad/suspect parts are ignored and only
good parts are counted. The menu returns to the
part count selection screen shown in Figure 9–16.
Figure 9–14 Confirm Erase All Setups
Figure 9–15 Erasing All Setups In Process
Figure 9–16 Part Count Selection Menu
Figure 9–18 Confirm Counter Enabled
Figure 9–17 Confirm Reset Part Count
