84
Dukane Manual Part No. 403–566–01
DPC
™
II Plus and EZ Welder System – User’s Manual
Table 7—I below summarizes the various method
and mode menus and references their Figure num-
ber. Table 7–II on the next page lists the data en-
try screens and references their Figure number. It
also gives the minimum and maximum values for
each of the parameters. The only variation be-
tween models is for weld energy. The high–fre-
quency (50kHz and 70kHz) models have a lower
power output, and the scale factor change enables
0.1 Joule resolution at these lower power levels.
Remarks
7–36Momentary or Maintained
TRIGGER TYPE
7–38Single or Dual Pressure
WELD MODE
7–39Time or Energy
WELD METHOD P1
7–41Time or Energy
WELD METHOD P2
7–35Manual or Auto
INITIATE MODE
7–26, 7–48Enable or Disable
AFTERBURST
7–25, 7–47Afterburst
PROCESS CONTROL
7–23, 7–45Hold Time
PROCESS CONTROL
7–22Weld Method
PROCESS CONTROL
7–37, 7–51Weld Mode
PROCESS CONTROL
7–15
WELD METHOD
Weld By Time, Energy or Ground Detect
7–13Enable or Disable
AUTO STOP
7–8Weld By Time or Energy
WELD METHOD
7–6Probe - Timed or Untimed
TRIGGER METHOD
7–34Press
TRIGGER METHOD
7–4, 7–29
7–33, 7–52
Root Menu
PROCESS SETUP
6–3, 7–3
7–4, 7–53
Previous Weld Cycle Data
WELD CYCLE DATA
6–2, 7–2Installed Modules
CONFIGURATION
6–1, 7–1DPC II Plus Firmware Version and Date
STARTUP
Description Figure No.Menu Name
Dual Pressure Mode Only
Dual Pressure Mode Only
Press Trigger Method Only
Press Trigger Method Only
Press Trigger Method Only
Press Trigger Method Only
Probe Trigger Method
Press Board or Power Output
Modules
Table 7—I Process Control Menu Listing
