Troubleshooting
90
fCannot connect in "Advanced Connection Mode" or wired LAN connection
fThe Slide show cannot be displayed on the desired display when using the multi-screen display.
fApplications are no longer displayed from the computer's screen when using the multi-screen display.
Is the network cable connected correctly?
Check that the network cable is connected correctly. Reconnect it if it is not connected or not connected
properly.
Check Remedy
Are the SSID for the computer, access point, and
projector different?
Set the computer, the access point, and the projector to the same SSID. See the projector User’s Guide for
more information.
Are the WEP keys set properly? When selecting WEP from "Security", set the access point, the computer, and the projector to the same WEP
key. See the projector User’s Guide for more information
Are the connection denial functions, such as MAC
address restrictions and port restrictions, set correctly
at the access point?
Set the projector to allow connections from the access point.
Are the IP address, the subnet mask, and the gateway
address for the access point and the projector set
correctly?
When not using a DHCP, adjust each setting. See the projector User’s Guide for more information.
Are the access point and the projector's subnet
different?
Select "Manual search" from EMP NS Connection, specify the IP address, and connect.
s p.40
Check Remedy
Are you using PowerPoint 2002 or an earlier version?
To set and use two or more virtual displays, use PowerPoint 2003, or limit the number of virtual displays to
one before displaying the Slide show.
Check Remedy
Is another application running on the virtual display?
When EPSON Virtual Display is installed, another application sometimes runs on the virtual display. If this
happens, set "EPSON Virtual Display" to "Off" in "Screen properties".
Check Remedy
For Wired LAN
For Windows
For Windows
