A
Tips for Administrator 237
A
A
A
A
A
A
A
A
A
A
A
Instructions on Using a Dial-Up Router
This section describes instructions on using a dial-up router.
If DHCP is used to assign an IP address of the printer and the
Dynamic DNS function is not supported, you need to change the
printer port setting every time you turn on the printer. Therefore,
we recommend that you set a valid IP address for the print server
by using the one of the following methods.
❏ Set the IP address for the print server manually. Use
EpsonNet WinAssist or MacAssist. See “TCP/IP” on page 58
or “TCP/IP” on page 83.
❏ Specify the print server by using the bind of DHCP function.
❏ Set the exclusive address of the DHCP function.
Note:
❏ Use NetBEUI printing if you do not want to go through these steps.
❏ See the manual of the Dial-Up router for more information on scorp
range, bind, exclusive address of the DHCP function.
