15-2
How to access and set a Setup menu
<Note>
You can access the Setup menu while the unit is
stopped and is not in the Utility or TC Setup mode.
Note that the operation procedure shown below is
not applied to the "
RS422 Setup
" and "
TCP/IP Setup
"
menus. See the explanations described later about
how to access and set those menus.
1. While the unit is stopped and the SHIFT indicator
is unlit, press the [SETUP] key.
The unit enters the Setup mode.
The first time the unit enters the Setup mode after
turning on the power, the first level of the "Adjust RTC?"
menu is shown on the display. Otherwise, the first level
of the Setup menu previously accessed is shown.
2. Use the jog dial (or the [SKIP/CURSOR |<<] / [SKIP/
CURSOR >>|] keys) to select a desired Setup
menu, and press the [ENTER/YES] key.
You can now set the selected menu.
The Setup menu changes in the order shown on the
right.
3. Use the jog dial (or the [SKIP/CURSOR |<<] / [SKIP/
CURSOR >>|] keys) to select a desired option, and
press the [ENTER/YES] key.
The selected option is confirmed and the display
returns to the first level.
4. Press the [EXIT/NO] or [STOP] key to exit the Setup
mode.
Flashing
SETUP
YMDHM
S
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
