GNS 430(A) Pilot’s Guide and Reference
190-00140-00 Rev. P
1-10
SECTION 1
INTRODUCTION
Page Groups
Page Groups
NAV Group WPT Group AUX Group NRST Group
see Section 3 see Section 7 see Section 10 see Section 8
Table 1-1 Page Groups
The bottom right corner of the screen (Figure 1-13)
indicates which page group (Table 1-1) is currently being
displayed, the number of pages available within that group
(indicated by square icons), and the placement of the
current page within that group (indicated by a highlighted
square icon).
In addition to the NAV Page Group, additional page groups
are available for waypoint information (WPT), auxiliary
(AUX) functions such as ight planning or unit settings, and
listings for nearest (NRST) airports or other facilities.
Figure 1-13 Current Page and Page Group
Current Page Group
Number of Pages in
Current Page Group
Position of
Current Page
within Current
Page Group
To select the desired page group:
Turn the large right knob until a page from the
desired page group is displayed (Figure 1-13).
To select the desired page within the page
group:
Turn the small right knob until the desired page
is displayed (Figure 1-13).
NAV Pages
There are seven pages available under the NAV Page
Group*:
• Default NAV Page
• Map Page
• TERRAIN Page
• NAV/COM Page
• Position Page
• Satellite Status Page
• Vertical Navigation Page
The Default NAV Page, the Map Page, and the NAV/
COM Page are used for most of the in-ight navigation.
NOTE: *Eight or nine NAV pages are available
when the GNS 430 installation includes
connection to traffic and/or weather information
sources. See the 400/500 Series Display
Interfaces Pilot’s Guide Addendum, p/n 190-
00140-10, or Section 12, Additional Features.
To select the NAV Page Group and display
the Default NAV Page:
Press and hold the CLR Key.
To select the desired NAV Page:
Turn the small right knob until the desired
page is displayed.
