APPN Configuration Command Detail
Enable/Disable
Use the enable/disable command to enable (or disable):
Syntax:
enable
appn
[or disable] dlur
port
port name
Set
Use the set command to set:
Syntax:
set
node
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Table 4. Configuration Parameter List - APPN Routing
Parameter Information
Parameter
Enable APPN
Valid Values
Yes, No
Default Value
Yes
Description
This parameter enables or disables the router as an APPN network node.
This parameter enables both APPN and HPR routing capability for this network node
which consists of defining the Network ID and CP name for this node. APPN, however,
must be enabled on the particular ports on which you desire to support APPN routing.
Additionally, support for HPR must be enabled on the particular APPN ports desired
and must be supported by the particular link stations on those ports.
Note: HPR only supported on LAN, frame relay and PPP direct DLC ports.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 83
