Page 42
7038-159D
November 28, 2011
5700 Step Top Wood Stove Series ACC
Installing Pedestal Assembly
1.
Slide pedestal over adapter on bottom of stove and
secure with screws supplied with the kit. Figure 42.1.
2. Line up holes in sides of pedestal with holes in adapter.
3. Securely tighten pedestal into place.
4. Slip wooden decorative strips onto pedestal edges
before lifting up stove.
5. Carefully stand stove up and place in desired location.
Finishing the ARS Installation
1. Re-install the ash grate channel
and secure with 2
bolts previously removed. Set the ARS access cover
and the 3 front cut bricks in place.
Figure 42.2.
2. Install the ash drawer.
3.
Check to make sure baffl e boards and ceramic blanket
are in their proper locations. See page 12.
NOTE: If installing an outside air kit with a pedestal assembly
as a fl oor installation you must attach the enclosed cover
plate to the back of the stove. Other wise you may discard
this piece. Figure 42.3.
Pedestal and Ash Removal System (Cont’d)
Figure 42.3
Figure 42.2
Ash Removel
Drawer
Adapters
Oak
Pedestal
Trim
Figure 42.1
ARS
Channel
ARS
Cover
Remove 3 Bricks
from Firebox
