November 28, 2011
7038-159D
Page 45
5700 Step Top Wood Stove Series ACC
E. Blower Installation (Optional)
1. Align holes in mounting fl ange of blower with bolt holes in
appliance. Blower should be positioned at bottom of rear
outer skin as shown in Figure 45.1.
2. Insert and tighten bolts supplied with the kit, securing
blower onto outer wall of appliance.
3
Place the bracket containing the snap disc and magnet
under the bottom left rear corner as shown in Figure 45.1.
See pages 15 and 21 for detailed operating instructions
for the blower and snap disc.
Figure 45.1
The blower speed control for this unit is adjusted at the factory,
and normally does not require further adjustment.
F. Adjusting the Blower Speed Control
NOTE: When the speed control is turned clockwise, it
will click on to high speed. Continue to turn the speed
control clockwise to decrease the speed. At full clock-
wise, the blower should blow gently, but should not
stop.
Snap Disc
Bracket
with
Magnet
Secure wires
with wire tie
MANUAL: Over-rides the
Snap Disc
AUTO: Fan will turn ON/OFF
Automatically by the Snap Disc
Controls the Fan Speed
MANUAL
FAN
AUTO
LOW
HIGH
OFF
CAUTION! Risk of Shock!
• Do NOT remove grounding prong from plug.
•
Plug directly into properly grounded 3 prong receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front of appliance.
