6.5 GT11
6.5.1 General Specifications (GT11)
2.4 W or less (100 mA or less)
Note1)
°
°
°
10 to 85% RH (at 25 °C, non-condensing)
Breakdown voltage
Between [power supply terminals] and [case]
500 V AC for 1 minute, Cutoff current 10mA (at default setting)
Insulation resistance
Between [power supply terminals] and [case]
100 MΩ or more, 500 V DC, measured with megohmmeter (at default
Vibration resistance
10 to 55 Hz (1-minute cycle)
Amplitude: 0.75 mm,
Shock resistance
4 times on 3 axes
EMC Directive: EN61000-6-2, EN61000-6-4
Noise immunity
1000 V [P-P] or more, Pulse width 50 ns, 1µs between power supply
terminals (based on in-house measurements)
Note3)
Protective construction
IP65 (Initial value, evaluated by us)
Dustproof and drip-proof from front panel only (packing used on panel
Note4)
Note1) When connecting the FP programmer II to the TOOL port, it is 150 mA or less.
Note2) When connecting the FP programmer II or C-NET adapter to the TOOL port, the usable range is
0 to +45 °C.
Note3) When using our exclusive cable.
Note4) When reattaching, replace waterproof packing.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
