Ethernet port (GT32T1 only)
Item
Communication standard IEEE802.8u/100BASE-TX IEEE802.3/10BASE-T
Plug-in phone jack
Note2)
Applicable cable UTP cable (Unshielded wire) Category 5
Auto MDI-X Supported
SPEED lamp
Light on: During 100BASE-TX communication
Blinking: During 10BASE-TX communication
LINK/ACT lamp
Light on: When linked
Blinking: During data reception.
Note1) Data processing in the main unit is carried out with the serial communication of 115.2 kbps.
Note2) Take care of handling of the connector not to add an excessive static electricy on the metal part
of the connector.
Note3) Do not use a STP cable (shielded wire).
Note4) Ethernet is a trademark of Zerox Corporation, USA.
Note5) Simultaneous communication with the USB port is not achievable.
SD memory card slot
Support media SD memory card, SDHC memory card
Supported format standard
Conforms to SD standard
Note2)
Note1) The manufacturer name that the operation check has done: Panasonic Corporation
Usable capacity of a SD memory card varies according to the version of GT firmware.
Note2) Please format with a format software for SD memory cards.
Note3) The SD access lamp turns on while acccessing the SD memory card.
6.8.5 Sound Output Specifications (GT32T1 Only)
Item
WAV format (PCM format, sampling 8 KHz, 16 bits monoral)
Max. sound data capacity 512 kbytes (Approx. 30 seconds)
Max. registered No. of
sound data
128
φ
Connecting amplifier Input impedance 10 kΩ or more
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
