1. Introduction and Installation
10
Installation
1.5 Toner cartridge and drum unit
The included toner cartridge is a starter toner cartridge.
It will print about 500 A4-sized pages with a 5 % image
area (page 65).
L To replace the toner cartridge and the drum unit, see
page 53.
Caution:
L Read the following instructions before you begin
installation. After you have read them, open the
drum unit protection bag. The drum unit contains
a photosensitive drum. Exposing it to light may
damage the drum. Once you have opened the
protection bag:
– Do not expose the drum unit to light for more
than 5 minutes.
– Do not touch or scratch the black drum
surface.
– Do not place the drum unit near dust or dirt,
or in a high humidity area.
– Do not expose the drum unit to direct
sunlight.
L Do not leave the toner cartridge out of the
protection bag for a long time. It will decrease the
toner life.
1 Before opening the protection bag of the new toner
cartridge, shake it vertically more than 5 times.
2 Remove the toner cartridge and drum unit from the
protection bags. Peel off the seal (1) from the toner
cartridge.
L Do not touch or scratch the black drum surface
(2).
3 Place the toner cartridge (1) into the drum unit (2)
vertically.
4 Turn the lever (1) on each side of the toner cartridge
while pressing down firmly.
5 Make sure that the triangles (1) match, to install the
toner cartridge correctly.
6 Lift open the front cover (1), holding the OPEN tab
(2).
1
2
1
2
1
1
1
2
FL313HK-PFQX2630ZA-en.book Page 10 Tuesday, August 29, 2006 10:19 AM
