A SERVICE OF

logo

Hardware Installation SY-P4I875P DRAGON 2 V1.0
28
5. IDE LED
Attach the 2-pin IDE device LED cable to the corresponding IDE LED
header on the Motherboard. This will cause the LED to light when an IDE1 or
IDE2 (HDD, CD-ROM) device is active.
6. ATX Power On/Off Switch
Attach the 2-pin momentary type switch to the PWRBT header for turning On
or Off your ATX power supply. Note that 5VSB will always have power, so
the 5V standby LED will always be lit.
HDD LED Pin Assignment
+
_
LED Anode LED Cathode
PWRBT Pin Assignment
Power On/Off GND
1