Hardware Installation SY-P4I875P DRAGON 2 V1.0
43
Onboard LAN LED Definition
Step 5 Power On
You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system is
performing the diagnostic checks,
Note: If you have failed to enter the BIOS Setup utility, wait until
the boot up sequence is completed. Then push the RESET button
and press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
When this LED is lit
(green sign), this means
the LAN is running at 100
mbps, if it is not lit, the
Onboard LAN is working
at 10 mbps.
This is the LAN activity
LED. It will blink when
it is active.
When this LED is lit (red
sign), this means the LAN
is running at 1 Gbps, if it
is not lit, the Onboard
LAN is working at 10
mbps.
This is the LAN activity
LED. It will blink when
it is active.
