4. Use the Hour and Minute pads to set the
desired start time.
Push
the “up” (A) or
“down” (V) pad(s) until the correct time
shows in the display.
This example shows a desired start time
of 2 o’clock.
5. Push
the Stop Time pad. The time of day
with the colon flashing will show in the
display and STOP TIME will light up.
6.
7.
Use the Hour and Minute pads to set the
desired stop time.
Push
the “up” (A) or
“down” (V) pad(s) until the correct time
shows in the display.
This example shows a desired stop time of
2:30. This provides a cook time of 30 minutes
(the difference between the start and stop
times).
NOTE: If you do not set a stop time, the colon
will flash in the display and STOP and COOK
will flash alternately to remind you to program
a stop time or a cook time. (See page 21 for
instructions on how to set delay start and stop
automatically using Cook Time and Start
Time.)
Push the Start/Enter pad. DELAY and BAKE
will light up in the display to show that the
oven is programmed to start at a later time.
NOTE: The display will show “door” and a
tone will sound once a minute for 5 minutes if
the door is latched when you try to bake/
roast.
You can change the temperature or time
settings any time after pushing the Start/Enter
pad by repeating just Steps 2 through 6.
24
