26
CONNECTIONS
Follow the procedure below to change the impedance
setting for all speakers.
If you are using 6 ohm speakers, set the impedance to
6 ohms before using this unit.
Be sure this unit is in the standby mode.
1 On the front panel, while holding down
STRAIGHT/EFFECT, press STANDBY/ON.
“SP IMP.–8ΩMIN” appears on the front panel
display.
2 Press STRAIGHT/EFFECT to select the
impedance of your speakers.
If you are using 6 ohm speakers, select 6 ohms; if you
are using 8 ohm speakers, select 8 ohms.
3 Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
Speaker impedance setting function is located in the Advanced
menu (see page 86).
When all connections are complete, turn on the power of
this unit.
1 Press STANDBY/ON (or SYSTEM POWER on
the remote controls) to turn on the power of
this unit.
2 Turn on the video monitor connected to this
unit.
Press STANDBY/ON again (or STANDBY on the remote
control) to enter the standby mode.
Speaker impedance setting
CAUTION
Note
STRAIGHT
EFFECT
STANDBY
/ON
SP IMP.-8 MIN
Turning on the power
Note
A
SPEAKERS
B
MULTI CH
INPUT
AUDIO
SELECT
TONE
CONTROL
STRAIGHT
PRESET/
TUNING
EDIT
MAN'L/AUTO FMAUTO/MAN'L EFFECT
TUNING
MODE
MEMORY
MAIN ZONE 2
ZONE ON/OFF
ZONE 3
ZONE CONTROL
FM/AM
A/B/C/D/E
SOURCE/
REMOTE
REC OUT/ZONE 2
SILENT CINEMA S VIDEO VIDEO L
VIDEO/AUX
AUDIOR OPTICAL
PHONES
PRESET/
TUNING
OPTIMIZER
MIC
VOLUME
PROGRAM
INPUT
PURE DIRECT
STANDBY
/ON
MD/TAPEDVD
DTV
CBL/SAT
VCR 1
CD-R
TUNER
CD
DVR/
VCR 2
1
SELECT
DTV DVR/VCR2VCR 1 DVD
V
-
AUX
CBL/SAT MD/TAPE
CD-R
PHONO TUNER CD
MULTI CH IN
+
POWER POWER POWER
SYSTEM
STANDBY
AVTV
SLEEP
AUDIO SELECT
A
B
++
AMP
1
STANDBY
/ON
POWER
SYSTEM
or
Front panel
Remote control
