62
SYSTEM OPTIONS
■ Test Tone (Test tone)
Turns the test tone output on or off for Speaker Set,
Speaker Distance and Speaker Level settings.
Manual Setup > Basic > Test Tone >
Choices: Off, On
y
• If you use a handheld SPL meter, hold at arms length and point
upwards so that the meter is in the listening position. With the
meter set to the 70 dB scale and to C SLOW, calibrate each
speaker to 75 dB.
• This menu item is also available in the front panel display
system options menu (see page 88).
Loud test tones will be output when “On” is selected. In this case,
make sure no children are present in the listening room.
■ Speaker Set (Speaker set)
Use to manually adjust any speaker setting.
Manual Setup > Basic > Speaker Set >
Choices: Front, Center, Surround, Surround Back,
Presence, Bass Out, Bass Cross Over, SWFR Phase
y
If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
Set any THX speakers to Small.
Front (Front speakers)
Choices: Large, Small
• Select “Large” if you have large front speakers. The
unit directs the entire range of the front left and right
channel signals to the front left and right speakers.
• Select “Small” if you have small front speakers. The
unit directs the low-frequency signals of the front
channel to the speakers selected with Bass Out.
Center (Center speaker)
Choices: Large, Small, None
• Select “Large” if you have a large center speaker. The
unit directs the entire range of the center channel signal
to the center speaker.
• Select “Small” if you have a small center speaker. The
unit directs the low-frequency signals of the center
channel to the speakers selected with Bass Out.
• Select “None” if you do not have a center speaker. The
unit directs all of the center channel signal to the front
left and right speakers.
Surround (Surround left/right speakers)
Choices: Large, Small, None
• Select “Large” if you have large surround left and right
speakers or if a rear subwoofer is connected to the
surround speakers. The entire range of the surround
channel signal is directed to the surround left and right
speakers.
• Select “Small” if you have small surround left and right
speakers. The low-frequency signals of the surround
channel are directed to the speakers selected with Bass
Out.
• Select “None” if you do not have surround speakers.
This sets the unit to the Virtual CINEMA DSP mode
(see page 39) and automatically sets the surround back
speaker setting (Surround Back) to “None”.
Note
Note
Off
On
Speaker Set
Speaker Distance
Test Tone
Large
Small
Center
Surround
Front
Large
Small
NoneSurround
Surround Back
Center
Front
Large
Small
NoneSurround Back
Presence
Surround
Center
Front
