Filter
Top Products
Not for commercial use – Ericsson Inc.
Getting Started 9
Complete the following procedures to set up your
mobile phone for the first time:
• Review the document conventions used in this
guide by referring to the “Document Conventions”
chapter.
• Attach the belt clip to the phone by referring to the
Attaching the Belt Clip to Your Phone section in
this chapter.
• Fully charge and condition your battery by refer-
ring to the Charging Your Battery section in this
chapter.
• Turn your phone On by referring to the “Basic
Operations” chapter.
Attaching Your Standard or Swivel Belt Clip
Your Ericsson mobile phone is equipped with either a
standard or swivel belt clip:
Standard Belt Clip
1
Remove the belt clip from the plastic bag.
2
Remove the flexible rubber plug from the top of the
clip.
3
While making sure that the screw is going through
both the plastic clip and through the metal support
guide, insert the screw into the opening on the back
of the phone.
4
Using a small Philips head
screwdriver, turn the screw
clockwise until it is secure as
shown in the following illus-
tration. Do not over tighten
the screw.
5
Inserting the two smaller prongs first, replace the
flexible rubber plug at the top of the clip.
Swivel Belt Clip
1
Align the screw-in tab
between the two guides on
the back of the phone, with
the thicker end on top.
2
Using a screwdriver, attach
the tab to the phone.
3
Place the swivel belt clip on
your belt or waistband.
4
Slide your phone, with tab, into the swivel belt clip.
To remove, press the release mechanism on the top
of the clip and slide the phone up and out of the
clip.
Getting Started
Push to
release phone