Filter
Top Products
Not for commercial use – Ericsson Inc.
12 Getting Started
6
Continue charging the phone until the battery is
fully charged.
Note! If the phone is powered On, the battery icon is replaced
by the icon once the battery is fully charged.
Note! If the phone is in charge-only mode, Charging Com-
plete appears in the display once the battery is fully
charged.
Travel Charger
The travel charger supplies power to charge your battery
while the battery is attached to your phone. If your
phone is On, it can receive calls while using the travel
charger.
To charge your battery using the travel charger:
1
Connect
the appro-
priate AC
power cord
and phone
charging
cord to the
travel charger.
2
Plug the AC power cord into a standard electrical
wall outlet.
3
Hold the phone with the display and keypad facing
up.
4
Hold the small plug on the charger cord so the light-
ning bolt symbol is up (see diagram on previous
page).
Note! Do not twist while inserting or removing the small
plug on the charger cord!
5
Align the small plug on the charger cord with the
connector on the bottom of your phone. The con-
nector on the phone is above the lightning bolt sym-
bol.
6
Press the plug into the connector until the plug
“snaps” into place.
Desktop Charger
The desktop charger can charge a battery attached to
your phone (standing in the front compartment of the
charger) and a separate battery (in the rear compartment
of the charger). The desktop charger can also condition
the separate battery by discharging the battery com-
pletely before beginning the charging cycle.
Connecting the Power Cord to the Desk-
top Charger
To connect the charger plug to the desktop charger:
1
Using the lightning bolt symbols as your guide,
align the small plug on the power cord with the
receptacle on the back of the desktop charger (see
diagram on previous page).
2
Hold the small plug with the lightning bolt symbol
facing up, and press the plug into the receptacle on
the back of the desktop charger until the plug
“snaps” into place.