Filter
Top Products
IQ8Wireless transponder for wall mounting
26 FB 798941 / 10.06
7 General
The IQ8Wireless transponder, in combination with the associated IQ8Wireless detector bases
(Part No. 805593) and IQ8Wireless interfaces enables the wireless connection of IQ8Quad
series fire detectors and may be used as a device on the analog loop of the IQ8Control fire
alarm system or as a stand-alone wireless control device in fire alarm systems with
conventional detector zones.
The IQ8Wireless system guarantees adequate protection against electro-magnetic
interference under normal ambient conditions. This module generates and uses electro-
magnetic radiation and may disturb other wireless transmissions if it is not used as intended or
not installed as described in the instructions. In principle, electro-magnetic influence of
equipment cannot be excluded for all installations. If this module causes electro-magnetic
interference on radios or televisions that cannot be rectified by switching the device on and off,
the following measures can be carried out to rectify the interference:
• Change the position of the wireless components
• Create a greater gap between the module which is exhibiting signs of interference and the
wireless components
System requirements
• Programming software tools 8000 from Version V1.09
• To operate the IQ8Wireless transponder as a loop device of the Fire Alarm Control
System IQ8Control, the IQ8Control operating system software Version V3.04 R001 is
required.
Accessories
Part No. Description
805593
IQ8Wireless detector base for automatic Fire detectors series IQ8Quad
(without integrated alarm device)
805594
IQ8Wireless Gateway automatic Fire detectors IQ8Quad
805597 4 Lithium batteries (type AA / 3,6V) for power supply
805601
IQ8Wireless universal Interface (red), without cover
805602
IQ8Wireless universal Interface (white), without cover
805603
IQ8Wireless Mounting frame for Alarm device IQ8Alarm (red + white)
805604
IQ8Wireless Mounting frame for automatic Fire detectors IQ8Quad (white)
805605
Cover for IQ8Wireless Interface 805601 und 805602 (red + white)
For the operation of the intelligent Fire alarm detectors series IQ8Quad with
integrated alarm device use Part No. 805602 and 805604.
Warranty claims will not be accepted in case of damage caused by
non-compliance with the operating instructions. The manufacturer is not liable for
subsequent damage resulting from the above. Please study the installation
instruction of the IQ8Wireless transponder carefully before installing.