Filter
Top Products
User Guide for the Kyocera KX12 Phone 1
1GETTING ST ARTED
Installing the battery
Your Kyocera KX12 phone comes with a
removable lithium ion (LiIon) battery.
Fully
charge the battery before using the phone.
To
charge the battery see “Charging the battery” on
page 2. Only connect the charger as instructed.
To install the battery:
1. Place the phone face
down with the battery
recess toward you.
2. Place the battery in
the phone recess with
the copper contacts
toward the bottom of the
phone (1). Press the
upper portion of the
battery into place (2).
3. Place the two tabs at the
top of the rear cover into
the openings at the top
of the phone assembly.
Press the rear cover onto
the phone.
4. Close the port plug over
the latch, charging jack,
and headset jack.
Removing the battery
Warning: Before you remove the battery, make
sure the phone is powered off.
1. Open the port plug.
2. Between the phone
jacks, there is a latch to
aid you in opening the
rear cover. Pull the top
of the latch outward to
release the rear cover.
3. Pull the rear cover away
to remove it from the
phone.
4. Press the battery toward
the bottom of the phone
and pull the battery out
of the recess.
82-N8191-1EN.book Page 1 Tuesday, January 17, 2006 2:56 PM