Filter
Top Products
Command-Line Interface
Using the commands
3-2 CellPipe™ 20 Series User’s Guide
Using the commands
The CLI of the CellPipe 20 Series consists of two hierarchical levels. Some of the
second-level commands display values or status of the selected commands from the
main level.
Note: Access to the CLI is possible without a password. When user enables a
password, the unit will time-out after 10 minutes if there is no activity on the unit.
Re-entering password is necessary to resume activity.
The CellPipe 20 Series units display two sets of main menu commands based on the
mode of operation—bridging or routing. The default list of main menu commands is
for bridging. See “Bridging commands” on page 3-3. When selected for routing, the
routing menus are displayed. See “Routing commands” on page 3-6.
Viewing the main menu
To view a list of the main menu commands, enter help at the >> prompt.
>> help
Displaying information about a command
To display information about a command, enter help followed by the name of the
command.
For example, in the LAN menu, you can display information about the setip
command as follows:
>lan> help setip
setip - setip <etherip[/<masknum>]> [subnet mask]
where etherip is the required information and [masknum] and [subnet
mask] are optional information.