Filter
Top Products
Configuring a 20 Series CellPipe
Configuring the pppoa command
4-14 CellPipe™ 20 Series User’s Guide
Select the setqos command to set the class for quality of service.
>ipoa> setqos [<vpi>/]<vci> <ubr|cbr|vbr(nrt)>
Select the setrip command to set the PVC for RIP.
>ipoa> setrip [<vpi>/]<vci> <1|2|1&2|0>
Select the setwanip command to set up to eight PVCs, the WAN IP addresses for
each PVC, and the gateway IP address.
>ipoa> setwanip [<vpi>/]<vci> <wanip[/<masknum>]> <gatewayip>
Select the show command to display the IPoA configuration.
> ipoa> show
IPoA setting:
FUNCTION VPI/VCI CLASS Wan IP/MaskNum GatewayIP RIP
Configuring the pppoa command
The following is a list of the menus available under the pppoa command:
adduser - add user ID and password
chpass - change user password
deluser - delete user
echo - set echo interval time
setllc - add LLC header on the packets
setqos - set class
setrip - set RIP configuration
show - show PPPoA configuration
Select the adduser command to set up a PVC, user ID, and select an authentication
protocol for a user.
>pppoa> adduser [<vpi>/]<vci> <userid> [<chap|pap>]
Select the chpass command to change the password for the user of a pppoa
connection.
>pppoa> chpass
Old Password:******
New Password:******