Filter
Top Products
Configuring a 20 Series CellPipe
Configuring LAN interface
CellPipe™ 20 Series User’s Guide 4-7
AS0_Dn_Latency_Actual <interleave>
LS0_Up_Bytes_Actual 0
LS0_Up_Latency_Actual <interleave>
Fast_R_Up_Actual 0
Interleave_S_Up_Actual 0
Interleave_D_Up_Actual 0
Interleave_R_Up_Actual 0
Fast_R_Dn_Actual 0
Interleave_S_Dn_Actual 0
Interleave_D_Dn_Actual 0
Interleave_R_Dn_Actual 0
Select the stnl command to configure the local ADSL coding type.
>adsl> stnl - <T1.413>|<g.Lite>|<g.Dmt>|<Multi-Mode>
Select the trellis command to enable or disable Trellis encoding.
>adsl> trellis <Enable>|<Disable>
Select the tx_pwr command to configure the transmitted power attentuation for a
range between 0 dB and 12 dB.
>adsl> tx_pwr <0> .. <12>
Select the tx_bin command to allow the user to limit bins used for special
configuration in the transmitted signal.
> adsl> tx_bin - <start_bin> <end_bin>
Configuring LAN interface
This section provides menus for configuring the LAN interface in both bridging and
routing mode.
Configuring LAN interface in bridging mode
The following is a list of the menus available under the lan command in bridging
mode: