Filter
Top Products
Tools
66
5. If you do not enter an exchange rate, the device will prompt you to do so.
Select OK. You can edit the exchange rate at anytime.
■ Timer
The countdown timer in your device enables you to enter a specific time (up to 99
hours and 59 minutes). When the time runs out, your device sounds an alarm.
Note: The countdown timer only works when the device is on. When you
turn off your device, the timer is no longer active.
Set the timer
1. In the standby mode, select Menu > Tools > Timer > Normal timer, Interval
timer, or Settings.
Use Normal timer to measure the countdown time for tasks that have one
period (timer name). Select Interval timer to save sets of countdown times
with more than one period.
2. Enter the time (in hh:mm:ss format), and select OK.
3. Enter a note for the timer, and select Start.
appears in the standby mode with the countdown timer set. When the time
runs out, your device sounds an alarm, displays the timer note, vibrates (if set),
and flashes its lights.
Press any key during the alarm to stop the alarm. After 30 seconds the timer alert
stops automatically.
Change the time
After you have set the timer, you can change the time.
1. With a normal timer set, in the standby mode, select Menu > Tools > Timer >
Change time.
2. Enter the new time, and select OK.
3. Leave the note as it is, or enter a new note; and select Start.
Interrupt the timer
After you have set the timer, you can stop the timer. In the standby mode, select
Menu > Tools > Timer > Stop timer.