Filter
Top Products
2. Insert the card into the microSD card slot with the contact surface facing down, and press it until it
locks into place.
3. Close the back cover of the device.
Remove the microSD card
Important: Do not remove the memory card in the middle of an operation when the card is being accessed. Removing
the card in the middle of an operation may damage the memory card as well as the device, and data stored on the
card may be corrupted.
You can remove or replace the microSD card during phone operation without switching the device off.
1. Make sure that no application is currently accessing the microSD memory card.
2. Remove the back cover of the device.
3. Press the microSD card slightly in to release the lock.
4. Remove the microSD card from the slot.
Charge the battery
Check the model number of any charger before use with this device. This device is intended for use when supplied with power
from the AC-3 or AC-4 charger.
Warning: Use only batteries, chargers, and enhancements approved by Nokia for use with this particular model. The
use of any other types may invalidate any approval or warranty, and may be dangerous.
For availability of approved enhancements, please check with your dealer. When you disconnect the power cord of any
enhancement, grasp and pull the plug, not the cord.
1. Connect the charger to a wall socket.
2. Connect the lead from the charger to the socket on the bottom of your device.
If the battery is completely discharged, it may take a few minutes before the charging indicator appears
on the display or before any calls can be made.
The charging time depends on the charger used. Charging a BL-4C battery with the AC-3 charger takes
approximately 2 hours and 45 minutes while the device is in the standby mode.
Switch the device on and off
To switch the device on or off, press and hold the power key.
See "Keys and parts," p. 10.
If the device prompts for a PIN or a UPIN code, enter the code (displayed as ****), and select OK.
The device may prompt you to set the time and date. Enter the local time, select the time zone of your location in terms of the
time difference with respect to Greenwich mean time (GMT), and enter the date. See "Time and date," p. 24.
When you switch on your device for the first time and the device is in the standby mode, you may be prompted to get the
configuration settings from your service provider (network service). For more information refer to Connect to support. See
"Configuration," p. 27. See "Configuration setting service," p. 7.
Antenna
Your device has an internal antenna
Note: As with any other radio transmitting device, do not touch the antenna unnecessarily
when the device is switched on. Contact with the antenna affects call quality and may cause
the device to operate at a higher power level than otherwise needed. To optimize antenna
performance and battery life, avoid contact with the antenna area when operating the device.
Headset
Warning: Listen to music at a moderate level. Continuous exposure to high volume may damage your hearing.
Pay special attention to volume level if you connect any other headsets to the device.
Warning: When you use the headset, your ability to hear outside sounds may be affected. Do not use the headset
where it can endanger your safety.
G e t s t a r t e d
© 2007 Nokia. All rights reserved.
9