Filter
Top Products
[ 90 ]
End calls
To end a conference call, that is, to disconnect with all callers, press the
End key. Or you can also press Options, then select End all calls.
Go from conference call to individual call
While all three parties are connected, pressing the Send key places the
second call on hold, while keeping the first party’s call active. Pressing the
Send key again will switch you to the second call, while placing the first
call on hold. Pressing the Send key again will bring all parties into the call.
Disconnect one party from the conference call
If you wish to disconnect with the first party and remain connected to the
second party, have the first party terminate the call on his/her end.
• SEND OWN CALLER ID WHEN CALLING
This feature allows you to block caller ID when you call someone (your
number will not be displayed on their caller ID). This feature may only be
effective when calling a number equipped with caller ID.
Note: This feature is available only when supported by the
wireless network and may not function if you are roaming.
Important: This feature works on a call-by-call basis. You must
enable this feature each time you want to block the sending of
your own number to the recipient’s caller ID.
Store the feature codes
Before you can use the Send own caller ID when calling feature, you
must store the feature codes for activating this feature. Once the code is
stored in your phone, it is sent automatically to the network when you
select this option from your phone’s menu.
1 Press Menu 4-6-5 (Settings > Network services > Network feature
setting).
The Feature code field appears after a few seconds.