Filter
Top Products
Settings
40
• Voice tags are sensitive to background noise. Record voice tags and use them
in a quiet environment.
• Very short names are not accepted. Use long names and avoid similar names
for different numbers.
Note: Using voice tags may be difficult in a noisy environment or
during an emergency, so you should not rely solely upon voice dialing
in all circumstances.
■ Call settings
Location info sharing
Location info sharing is a network service. See "Network Services," p. 6.
If your wireless service provider supports this feature, then location info sharing
allows the phone to share position information over the network. For calls to
emergency numbers, this position information may be used by the emergency
operator to determine the position of the phone. The functionality and accuracy
of this feature is dependent on the network, satellite systems, and the agency
receiving the information. It may not function in all areas or at all times.
Location information will always be shared with the network during emergency
calls to the official emergency number programed into the phone, regardless of
which setting is selected. After placing an emergency call the phone remains in
emergency mode for 5 minutes. During this time, the location information will be
shared with the network. For more information, see "Emergency calls," p. 74.
In the standby mode, select Menu > Settings > Call settings > Location info sharing >
911 only or Location on > OK > OK.
Emergency —This is the default profile. The phone location information is shared
only during an emergency call to the official emergency number programed into
your phone. The phone screen displays in the upper left-hand corner of the
standby mode.
Location on —The phone location information is shared with the network whenever
the phone is powered on and activated. The screen displays in the upper left
hand corner of the standby mode.
Anykey answer
Anykey answer allows you to answer an incoming call by briefly pressing any key
except the power key, right selection key, or end key.
In the standby mode, select Menu > Settings > Call settings > Anykey answer >
On or Off.