Filter
Top Products
Setting up SMS
SMS allows you to send and receive text
messages.
Important:
R To use SMS features, you must:
– subscribe to a Caller ID and/or an
appropriate service such as SMS.
– confirm that SMS is turned on.
– confirm that the correct message centre
numbers are stored.
Contact your service provider/telephone
company for details and availability.
Note:
R A total of 22 messages (at 160 characters/
message) can be saved. Total number may
be more than 22 if length of messages is
less than 160 characters/message.
R If the unit is connected to a PBX system,
you may not be able to use SMS features.
Turning SMS on/off
1 MMenuN (right soft key) #357
2 MbN: Select the desired setting. a MOKN
a M N
Storing SMS message centre
numbers
SMS message centre numbers must be
stored in order to send and receive SMS
messages.
For Czech:
The message centre numbers (used for SMS
services provided by Telefonica O2) are
preprogrammed in this unit. You can change
them if necessary.
For Slovakia:
The message centre numbers (used for SMS
service provided by Slovak Telecom - T-Com)
are preprogrammed in this unit. You can
change them if necessary.
R Contact your service provider/telephone
company for more information.
R If you change the unit’s region setting/reset
the base unit, the stored message centre
numbers will be deleted or changed
(page 22). In this case, store the numbers
again if necessary.
1 To store “Message Centre1”:
MMenuN (right soft key) #351
To store “Message Centre2”:
MMenuN (right soft key) #352
2 Edit the number as necessary. a MOKN
a M
N
Note:
R For PBX users:
– You need to add the PBX line access
number and a dialling pause to the
beginning of the Message Centre 1
number.
– If you only use the Message Centre 1
number for SMS, store the Message
Centre 1 number as is (without adding a
line access number or dialling pause) to
Message Centre 2.
Sending a message
Writing and sending a new
message
1 MMenuN (right soft key) a
a MOKN
2 MbN: “Create” a MOKN
3 Enter a message. a MOKN
R You can change the character entry
mode by pressing MR/ECON
(page 43).
4 Enter the destination phone number (20
digits max.). a MOKN 2 times
R You can also set the phone number:
– from the redial list by pressing MTN.
– from the caller list by pressing M
N.
– from the phonebook by pressing
MWN.
5 To save the message, select “Yes”. a
MOKN
6 To send the message, press MOKN.
Note:
R This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
37
SMS (Short Message Service)
PRW110FX(en)_0724_ver012.pdf 37 2013/07/24 13:40:27