Filter
Top Products
37
Pairing
All FLX2 wireless components are paired before the system is shipped, providing much
of the system setup already completed. While pairing should not be required for the
system to work, sometimes components can require pairing if a part is shipped
separately. The following aree instructions on how to pair the wireless components of
the system to the FLX2 Conference Phone.
To pair the FLX Dialer, follow this procedure. Please note that Microphones and
Speakers require a Dialer to be paired with the Base Station before you can pair them.
Dialer
1. If the Dialer is turned on, turn it off by pressing and holding the red ‘end call’
button until an overlay appears asking whether you want to shut the Dialer down.
Press ‘Yes’.
2. Plug in the FLX2 Base Station.
3. Turn the Dialer back on (press the red ‘end call’ key). The screen should read
“Scanning for new base”. If the screen reads “scanning for paired base”, press
the ‘Stop’ button, press the ‘Menu’, and select ‘Re-Pair’. When asked whether to
‘Scan for New Base’, select ‘Yes’.
4. After some time scanning for available bases, an overlay will appear asking ‘Pair
with <System Name>?’ Select ‘Yes’.
5. An overlay, ’Pairing with base <System Name>’, should appear followed by a
‘Connecting…’ and then and ‘Initializing…’ screen. Shortly after that the Dialer
home screen will appear. Your Dialer is now paired.
6. If the Dialer does not automatically pair, repeat steps 1-5. If this still does not
resolve the problem, select “Reset Factory Defaults” as this will force a scan for a
new base.
Speaker
1. To pair a Speaker, if the Speaker is turned on, turn it off
by pressing and holding the button on the bottom of the
Speaker until you hear the Speaker shut-off or the
LEDs turn off.
2. Ensure that the Base Station is plugged in and powered
up.
3. On the Dialer, browse to the Pairing menu: Menu
Setup Advanced Setup Pairing.
4. Select SPK 1 (Speaker 1) and press the ‘Enter’ or ‘Pair’
key to enter pairing state.
5. The screen will display ‘Pairing Speaker 1’.
6. Press and hold the button on the bottom of the Speaker
until the LED turns solid red.
7. An overlay will appear on the Dialer “Pairing
Successful”, after that the screen should read ‘SPK 1
Linked’.
8. If pairing was unsuccessful, the Speaker will show an
alternating red -green slow blinking sequence indicating