Filter
Top Products
7
Quick setup for Telephone Conference Calls
While all components delivered with the Revolabs FLX2 Conference Phone are partially
charged, we recommend charging the Speaker, the Microphones, and the Dialer for at
least 8 hours or overnight before starting to use the system.
Please note that the Revolabs FLX2 Conference Phone comes with two different power
supplies. Please ensure that you are using the correct power supply when connecting
the Base Station and the Charger Base.
Connecting the Base Station
Place the Base Station close to the analog
telephone outlet you want to use for the
conference phone. Connect the Base Station
to the telephone network using the provided RJ
11 Telephone cable. Use the 5 Volt power
supply to connect the Base Station to mains
power.
The Base Station will power up.
Connecting the Charger Base
Place the Charger Base at a location where
you can easily access the Microphones and
the Speaker for your conference calls, e.g. on
a side board, a desk, or the conference table.
Connect the Charger Base to the mains power
using the provided 12-15V power supply.
Place the Speaker, the Microphones, and the
Dialer in the respective openings of the
Charger Base to charge them.
The Microphones, Dialer and Speaker will
automatically connect to the Base Station after
a short time if it is powered up. You will hear a
confirmation chime from the Speaker once the
system is ready for use. If any of the
Microphones, the Speaker, or the Dialer is not
powered up, take them out of the Charger
Base for a few seconds and put
them back in. This will switch on
each of the components.