Filter
Top Products
41
2. The Base Station is powered up, but the Status LED indicates a fault by missing
every fifth green double flash. Power down and power up the Base Station. All
components should reconnect to the Base Station after a few seconds. If the
fault in the Base Station continues (every fifth double flash is skipped) please
contact Revolabs support.
3. Are the Dialer, Microphone, and Speaker out of reach of the Base Station?
Please bring the components closer to the Base Station to see whether this
resolves the issue.
4. Power down the Base Station, the Microphones, the Dialer, and the Speaker.
Now power up the Base Station. Once the Base Station is powered up (double
green flashes of the Status LED), power up the Dialer, and then the Microphones
and the Speaker. The components should now connect to the Base Station.
5. If the components still do not connect to the Base Station, please re-pair the
components that have not connected to the Base Station, beginning with the
Dialer. How to pair the components is explained on page 37.
6. If the components still do not connect to the Base Station, please contact
Revolabs support.
Microphone, Speaker, or Dialer not paired with Base Station
Please follow the descriptions on page 37 on how to pair the different components with
the Base Station.