Filter
Top Products
4 Strata DK Digital Telephone 5/99
The Grand Tour
Buttons
+ROG
(continued)
If the held party hangs up, the call is released and the CO provides a hold-
release signal.
Note If your telephone is programmed for Automatic Hold, existing calls are
automatically placed on hold when you answer a call or make another
call. (See “Automatic Hold” on Page 22.)
A different call can be held on each [DN] or /LQH
button on your phone. Each time you press 6FUROO,
a different [DN] or /LQH is selected. The selected
button’s LED flashes rapidly and your LCD displays
information for the call holding on that button
(samples shown at right).
0LF
(Microphone)
➤ Press to toggle the microphone ON/OFF while the telephone is in use. The
LED indicates the status of the microphone.
Notes
♦ The microphone and accompanying LED are always ON when receiving
“voice first” internal [DN] calls to enable Handsfree Answerback and OFF if
you receive a ring-first call. Mic may be ON/OFF when placing an on-hook
CO line or internal [DN] call.
♦ Each station’s Mic can be set in system programming to switch ON/OFF
with one touch, to switch OFF only while pressed and held, or to be either
ON/OFF at the start of handsfree dialing.
♦ To talkback to an HS-OCA call, press and hold Mic and talk over your
telephone handset/headset. The LED and microphone remain OFF during
OCA talkback operation (see “HS-OCA” on Page 52).
♦ Mic functions on Handsfree Answerback and OCA calls for privacy.
0VJ
(Message)
➤ When Msg LED flashes, press 0VJ to call back the station or voice mail
device that activated the LED (see “Message Waiting” on Page 48). This is
the telephone’s [PDN] message waiting button.
5HGLDO
➤ Press the same [DN] or /LQH that you used to dial the original number.
Press 5HGLDO. The last number called is redialed.
Note If you have Automatic Line Selection, you must first lift the handset.
Table 1 Fixed Button Definitions
(Continued)
Button Definitions
CO LINE 02
HOLD
DN 202
HOLD