Filter
Top Products
27
Set Time
When setting time, you must individually set each digit of the hour,
minute and second. To Set Time, select this menu icon from the
Device Setup Menu. Then select either a 12-hour, or a 24-hour clock
by highlighting your preference, and press the menu/OK button.
Use the scroll buttons, Phone Book and SOS, or “+” and “-”to
choose the correct number of 0 to 9. Press the menu/OK key to set
each desired time digit entry. Once you have set a part of the time
entry, you will be prompted to the next digit of the time-set entry. If you
make a mistake, you can press the Power Off/End button to go back
to the previous digit. If the time is set for the 12-hour mode, you will
be prompted to set either AM or PM when you have entered the last
digit. Press and hold menu/OK button for 4 seconds after you are
done to go back to the main menu.
Use the same procedure to set the time for a 24-hour time clock.
You will not have to select AM or PM.
There is no error checking as single digits are entered, but your
Wherifone will not accept an invalid time setting, such as 88:95:00.
Set Date
To Set the Date, select this menu icon from the Device Setup Menu.
You will then be able to set the date displayed on your Wherifone.
The screen will display the initial date setting with the number “0”
under the first Y in the YY column (Year), with no numbers under the
MM (Month) and DD (Day) columns.
G500Series UG_R5.qxd 7/18/06 1:54 PM Page 27