Module Problems
Firmware on this circuit module can be upgraded or reinstalled with an
Upgrade memory card. An upgrade is performed when a new release of
firmware enhances a module’s capabilities or corrects problems. Firmware
can be reinstalled if the existing circuit module firmware has been corrupted.
Summary
Console Procedure
Menu
→
Maintenance
→
Slot
→
Dial the slot
no.
→
Enter
→
Upgrade
→
Yes
PC Procedures
(F6)
→
(F2)
→
Type the slot no.
→
(F10)
→
(F8)
→
or
(F10)
→
(F4)
Appropriate Modules
This procedure can be run only on the 800
LS-ID module or modules introduced after
Release 3.0.
Time Estimate
Approximately 1.5 minutes.
Busy-Out or Reset
The module is automatically busied-out
after the upgrade procedure begins.
Restore
If Busy-Out is unsuccessful, you are given
the option of waiting for a Busy-Out or
selecting
Reset.
Restore the module after the upgrade
successfully completes.
Restore
is in the
Slot menu, which you can access by doing
the following from the console:
Menu
→
Maintenance
→
Slot
See "Restore,” earlier in this chapter, for
additional information.
Control Unit Problems 4-61
