A SERVICE OF

logo

In-Sight
®
1700 Series Wafer Reader Section 7: Native Mode Commands
65
7.2.2 Put PortNum
Put PortNum(<Input>)
Specifies the port that will be used by the In-Sight system for transferring data or images
over the network.
NOTES
The system must be offline when using the Portnum command.
The PortNum command must be executed before another device can connect to the specified port.
Inputs: 0 to 65535 to specify the port number.
NOTE A valid Port assignment is any unused number between 0 and 65535, except for reserved ports.
Output: Status Code
The status codes are:
STATUS CODE DESCRIPTION
1 The command was executed successfully.
0 Unrecognized command.
-1 The port number is invalid.
-2
The command could not be executed, the system is online, or the specified port is already in
use.
Sample Input and Output
PUT PORTNUM 3001
1