port-channel mode
Configure the LACP port channel mode.
Z9500
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active
state.
NOTE: LACP modes are defined in Usage Information.
passive Enter the keyword passive to set the mode to the passive
state.
NOTE: LACP modes are defined in Usage Information.
off Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information.
Defaults off
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
LACP Modes
Mode Function
active An interface is in an active negotiating state in this mode.
LACP runs on any link configured in the active state and also
Link Aggregation Control Protocol (LACP)
1133
