Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting Specifications
Perform the operations leading to playback on the AVR-4310CI in the
order shown below.
Audyssey™ Auto Setup (vpage 28)
Connections
Installing/Setting the Speakers
(vpage 11)
Speaker Connections (vpage 13)
Connecting Devices (vpage 14)
Turning the Power On (vpage 24)
Settings
Manual Setup (vpage 34)
Perform “Manual Setup” as necessary.b
Source Select (vpage 46)
Playback
Playing Components (vpage 53)
Selecting the Surround Mode (vpage 71)
Adjusting the Sound and Picture Quality
(vpage 73)
Flow of Operations Through
Playback
Cautions on Handling
• Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
•
Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
• About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
•
Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
Cautions on Installation
Note:
For proper heat dispersal, do not install this unit in a confined
space, such as a bookcase or similar enclosure.
b
b Note
b b
Getting Started
Getting Started
List of preset codes ··································End of this manual
Wall
Operating the Connected Devices by Remote
Control Unit············································································89
Operating the Main Remote Control Unit ································89
Operating AV Equipment ····························································89
Presetting ····················································································90
Operating Preset Components ···················································90
Setting the Remote ID ································································93
Learning Function ·······································································94
MACRO Function ········································································94
Punch Through Function ······························································95
Setting the Time the Backlight Stays Lit ·····································95
Adjusting the Backlight’s Brightness ···········································95
Specifying the Zone Used with the Main Remote Control ·········96
Resetting the Main Remote Control Unit ···································96
Operating the Sub Remote Control Unit ··································97
Switching Zones ·········································································98
Switching the Multi-zone Input Source to the Same Input Source
as Used in the MAIN ZONE ························································98
Setting the Zone for Which the Sub Remote Control Unit is Used
(ZONE SELECT LOCK Mode) ·····················································98
Setting the Remote ID ································································98
Resetting the Settings ································································98
Other Information ·······························································99
Troubleshooting·································································108
Restoring All the Settings to as They were at the Time of
Purchase (Resetting the Microprocessor) ·······························111
Specifications ······································································112
