Getting Started Connections Settings Playback Multi-zone Information Troubleshooting Specifications
Operating the Main Remote Control Unit
[MUTE]
[ iPod]
[ NET/USB]
[ DTU]
[ SAT TU]
[0 ~ 9]
[POWER ON]
[DEVICE
SELECTOR]
[POWER OFF]
[RC SETUP]
[MASTER
VOLUME]
[SOURCE
SELECT]
[ MAIN]
NET/USB
EL Display
Buttons
EL Display
Device select
button
A ~ G Preset memory block selection
TU df
Switching picture
MODE Direct play (Rhapsody)
MEMO Preset memory registration
Buttons
MENU/
SEARCH
Page Search /
Character Search
uio p
Cursor
ENTER Enter
SETUP/RSTR RESTORER
CH +/– Preset channel selection
1 ~ 8
Preset channel selection
(1 ~ 8)
When using multiple DENON AV receivers in the same room, make
this setting so that only the desired AV receiver operates.
Setting the Remote ID
NOTE
When changing a setting, be sure to set the same remote ID as the
AVR-4310CI’s (vpage 44).
When changing the MAIN mode’s remote ID, also change the
“SAT TU”, “DTU” “iPod”, and “NET/USB” remote ID at the same
time.
•
•
DEVICE
SELECTOR
Remote ID
MAIN
SAT TU
(SIRIUS,
XM)
iPod DTU NET/USB
1
(Default)
81001 52415 72815 62840 62865
2 82001 52416 72816 62841 62837
3 83001 52417 72817 62842 62838
4 84001 52418 72818 62843 62839
1
Press [MAIN] to light the “MAIN” zone indicator.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Refer to the table at the right, and use [0 ~ 9] to input
the 5-digit number corresponding to the remote ID
to be changed.
The signal transmission indicator flashes twice.
4
Press [SAT TU], [DTU], [iPod] or [NET/USB] to select
the mode to be set.
5
Repeat steps 2 to 4 to set the remote IDs for all
modes.
Signal
transmission
indicator
[0 ~ 9]
[DEVICE
SELECTOR]
[MACRO]
[RC SETUP]
Signal
transmission
indicator
Remote Control
