Getting Started Connections Settings Remote ControlMulti-zone Information Troubleshooting Specifications
The strength of both the XM satellite and terrestrial signals can be
checked “Antenna Aiming” (vpage 52).
Tuning in Radio Stations – XM Satellite Radio
Checking the XM Signal Strength and Radio ID
1
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display GUI Status
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
2
Adjust the position of the antenna until “SIGNAL:
GOOD” is shown on the display.
3
Press <STATUS> until the channel (example:
“XM001”) is displayed.
4
Press [TU d] or [TU f] and select channel 0
(XM000).
The radio ID is shown on the display.
Radio ID
Listening to XM Satellite Radio
The channel switches continuously when [TU d] or [TU f] is pressed
and held.
The artist name, song title, category and reception level can be
checked by pressing <STATUS>.
The time (default : 30 sec) for which the GUI menus are displayed
can be set “GUI” – “Tuner” (vpage 43).
Press uio p to return to the original screen.
•
•
•
When operating XM with the AVR-4310CI via the main remote control
unit or sub remote control unit, use [SAT TU].
Before operating, set to [SAT TU] operating mode.
[SAT TU] of [SOURCE SELECT] and [SAT TU] of [DEVICE SELECT]
mode can use only either XM or SIRIUS. The default setting is for
SIRIUS operation.
1
Set GUI menu “Option Setup” – “Remote (SIRIUS/
XM)” (vpage 44) to “SAT TU : XM”.
2
Press [SOURCE SELECT] to display the GUI Source
Select menu, then select “ ” (vpage 27).
The input source becomes that set in step 1.
3
Set the main remote control unit to the “SAT TU”
mode (vpage 89 “Operating the Main Remote
Control Unit”).
You can then operate the input source you set in step 1.
4
Use [TU d] or [TU f] to select the channel.
When the channel is tuned in, the name of the song and artist
are displayed.
5
Adjust the items below.
Adjusting the master volume (vpage 70)
Selecting the surround mode (vpage 71)
Adjusting the Sound and Picture Quality
(vpage 73)
n
n
n
<SOURCE SELECT>
<STATUS>
<TUNING PRESET>
ENTER
uiop
ENTER
[SEARCH]
[CHANNEL]
[A ~ G]
[0 ~ 9]
[SAT TU]
[MEMO]
[TUd]
[TU f]
[ SAT TU]
uiop
[SOURCE
SELECT]
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Sub remote control unit
Playback
(MAIN mode)
(MAIN mode)
