Getting Started Connections Settings Remote ControlMulti-zone Information Troubleshooting Specifications
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 stations can be preset.
“LOADING” is displayed while channels or data are being received.
Refer to “Troubleshooting“ – “XM Satellite Radio“ (vpage 111)
regarding other messages.
•
•
Accessing XM Radio Channels Directly
1
Press o p.
2
Use o p to select the category, to use ui to select
the desired channel.
Channel category
1
Press [SEARCH].
2
Press [0 ~ 9] to input the channel.
Example: Accessing channel “XM123”: Press [1], [2] and [3].
If no button is pressed within several seconds, the channel
automatically switches to the one whose number has been input.
b
3
Press ENTER to set that channel.
Reception switches to the selected channel.
You can also operate via the main unit. In this case, perform the
following operations.
Press <TUNING PRESET>, then turn <SOURCE SELECT> to select the
preset radio channel.
1
Press [A ~ G] to select the memory block.
2
Press [CHANNEL] or [1 ~ 8] to select the desired
preset channel.
1
Tune in the broadcast channel you want to preset.
2
Press [MEMO].
3
Press [A ~ G] to select the block in which the channel
is to be preset, then press [CHANNEL] or [1 ~ 8] to
select the preset number.
The memory block can also be selected by pressing [SHIFT] on
the sub-remote unit.
b
4
Press [MEMO] again to complete the setting.
Tuning in Radio Stations – XM Satellite Radio and SIRIUS Satellite Radio
Listening to Preset Channels
Searching Categories
The channel switches continuously when [TU d] or [TU f] is pressed
and held.
The song title, artist name, composer name, category and reception
level can be checked by pressing <STATUS>.
The time (default : 30 sec) for which the GUI menu are displayed can
be set “GUI” – “Tuner” (vpage 43). Press uio p to return to
the original screen.
•
•
•
When operating SIRIUS with the AVR-4310CI via the main remote
control unit or sub remote control unit, use [SAT TU].
Before operating, set to [SAT TU] operating mode.
[SAT TU] of [SOURCE SELECT] and [SAT TU] of [DEVICE SELECT]
mode can use only either XM or SIRIUS. The default setting is for
SIRIUS operation.
1
Set GUI menu “Option Setup” – “Remote (SIRIUS/
XM)” (vpage 44) to “SAT TU : SIRIUS”.
2
Press [SOURCE SELECT] to display the GUI Source
Select menu, then select “ ” (vpage 27).
The input source becomes that set in step 1.
3
Set the main remote control unit to the “SAT TU”
mode (vpage 89 “Operating the Main Remote
Control Unit”).
You can then operate the input source you set in step 1.
4
Use [TU d] or [TU f] to select the channel.
When the channel is tuned in, the name of the song and artist
are displayed.
5
Adjust the items below.
Adjusting the master volume (vpage 70)
Selecting the surround mode (vpage 71)
Adjusting the Sound and Picture Quality
(vpage 73)
n
n
n
Listening to SIRIUS Satellite Radio
Playback
