A SERVICE OF

logo

Effective 4/00
Page 21
IL 33-FX6-1
J. Install the new Retaining Plate on the Phase 2
Breaker using the original mounting hardware
removed in Step 10-D.
STEP 11: INSTALLING THE SENSORS
Fig. 46 New Retaining Plate Installed on Phase 2
A. Slide a Sensor over each top Breaker Stab, as
shown. Note that the Sensors must be
installed with the label facing away from the
Breaker and the terminals on the bottom.
B. Reinstall the Finger Clusters, removed in Step
2-G.
Fig. 47 Overview: Sensors and Sensor Harness
Installed on the Breaker