Effective 4/00
Page 7
IL 33-FX6-1
STEP 3: INSTALLING THE COPPER
CONNECTORS
Fig. 3 Overview: Copper Connectors Installed in
the Breaker
A. Align the new Copper Connectors with the
existing holes in the Stationary Contact
Assemblies.
B. Secure the Copper Connectors to the Station-
ary Contact Assemblies using the (6) original
spacers and the (6) .375-16 × 2.25" bolts, (12)
flat washers, (6) lock washers, and (6) nuts
supplied. Be sure to install the spacers in the
same locations as noted in Step 2-D.
Fig. 4 Spacer Location
For Kits Supplied with a PT Module Only: Only
tighten one (1) bolt on each Copper Connector.
The other bolts will be used to connect the PT
Wires later in the Retrofit Process.
Fig. 5 Copper Connector Installation
