Assembling the Printer
4.
Locate
the
drum unit, which you can recognize by the bright
green drum, and the cotton swab.
CAUTION: Do not expose the photosensitive drum to
light
any
longer than necessary (a few minutes at most). It
is recommended
that
you cover the drum with a soft cloth
or sheet of paper whenever the drum is exposed. Also, do
not touch the surface of the drum.
5.
Place the drum unit on a clean, smooth surface and locate
the
main charger wire, which extends along the length of the green
drum inside a slot in the silver bar directly over the drum. The
wire is silver and very thin, so it is difficult to see.
CAUTION: The main charger wire is very delicate. Do not
press
on
it too hard or it may break. Also, never touch
the
wire.
Setting Up the Printer
1-13
