38 - Connecting the video equipment
In the case of component (color differential*) image signals
· Connect the projector’s Computer 2/Component Video-BNC Port to the video equipment
with the component video cable (available on the open market) so that the following table is
supported.
· Connect the S-Audio/Audio #2 ports with the RCA audio cable supplied (red/white) to out-
put sound from the projector's speakers.
Point
· A conversion connector (available on the open market) is required on the projector's BNC
port when a component image cable is connected. Align the video with the equipment
port.
· Set the BNC parameter to [YCbCr] when the connection has been established. (see
page 70)
Video equipment R-Y(Cr) Y B-Y(Cb)
Projector R/R-Y G-RCG B/B-Y
R/Cr/Pr Port
G/Y Port
B/Cb/Pb Port
Audio Port (white)
Audio Port (red)
To the R-Y (Cr) output port
To the Y output port
To the B-Y (Cb) output port
RCA Audio Cable (supplied with the projector)
For component images
cable (available on the
open market)
To the audio output port L
(white)
To the audio output port R
(red)
Conversion connectors
(three, available on the
open market)
